墙壁安装灯具,易于安装和使用,大板是一个完美的住宅和商业墙砖装置解决方案,可以安装在室内或室外。确保安装纸张的表面是完全平坦的,干净的,没有裂缝,渗透或松散的材料。如果纸张安装到室外石膏,我们建议他们安装在抵抗各种应力的表面上(例如材料的重量,热扩张,天气条件等)。重要的是尊重Stringcourses和关节,并避免在非平面表面上安装,如砖墙。我们建议使用双涂层技术;首先在螺旋牙齿刮点的帮助下首先在底座上分布一层粘合剂,然后用扁平牙齿刮刀在片材背面施加3mm层。最后,我们建议铺设铺设的表面用橡胶刮刀击中并验证纸张是否遵守底部。



地板安装大型板块可以安装在住宅内饰,高交通商业环境,办公室,展厅和商店的地板上。我们建议不要在受重负荷通过的区域中安装纸张。在安装之前,请确保基板固化,干燥,不含裂缝并清洁碎片,混凝土块和灰尘。有关最佳安装,请检查底部的平整度,直边3毫米;确保最大间隙跨度不超过1毫米。如果有更大的差异,我们建议使用合适的平整或平滑产品。只要它平坦和紧凑,也可以安装在现有地板上(瓷砖,木材,石,棉碟)上安装的板坯。在安装之前,需要使用能够去除可能对粘合剂功能产生不利影响的表面润滑脂的碱性清洁剂来清洁表面。对于与上述支持不同的安装,直接与粘合剂的制造商联系。通过使用双涂层技术和齿的牙齿在6到8毫米之间的牙齿的帮助下安装产品。 Make sure to distribute the adhesive to the edges of the sheet and apply pressure to the installed surface with a rubber spatula or with your hands to facilitate the uniform adhesion of the glue and avoid the formation of air bubbles. We do not recommend using rubber materials for the adjustment of the sheets. Use a 1 or 2 mm joint when installing indoors and to guarantee sealing of the floor and the penetration of the grout between the sheets. It is important to respect all expansion joints. For surfaces up to 40-50 square meters we recommend a gap of 2 cm from the perimeter walls. In case of flooring on large surfaces, the use of flexible expansion joints is indicated; it is important to fraction the surfaces in 5x5 m areas and to use elastomeric sealants. They should be installed respecting the joints that are already present on the substrate. With pre-existing joints, it is important to not overlap the material and joints; the sheet should be cut in a way as to make them coincide or the pre-existing joint should be filled and then again at the edge of the material. We recommend waiting 12-48 hours from the time of installation before stepping on the floor and to adjust this time based on the adhesive used.

我们的网站使用cookie来提高您的浏览体验。
有关Cookie的更多信息以及如何使用浏览器设置控制Cookie的启用,请查看我们的
Cookie政策